Endress+Hauser Proline Prosonic Flow B 200 - Page 70

Commissioning Proline Prosonic Flow B 200 HART
70 Endress+Hauser
Parameter Prerequsite Description Selection / User
entry
Factory setting
Value per pulse One of the following options is
selected in the Assign pulse
output parameter (→  69):
• Volume flow
• Corrected volume flow
• Corrected methane volume
flow
*
• Mass flow
• Energy flow
*
Enter measured value at which
a pulse is output.
Signed floating-point
number
Depends on country
and nominal
diameter
Pulse width One of the following options is
selected in the Assign pulse
output parameter (→  69):
• Volume flow
• Corrected volume flow
• Corrected methane volume
flow
*
• Mass flow
• Energy flow
*
Define time width of the
output pulse.
5 to 2 000 ms 100 ms
Failure mode One of the following options is
selected in the Assign pulse
output parameter (→  69):
• Volume flow
• Corrected volume flow
• Corrected methane volume
flow
*
• Mass flow
• Energy flow
*
Define output behavior in
alarm condition.
• Actual value
• No pulses
No pulses
Invert output signal – Invert the output signal. • No
• Yes
No
* Visibility depends on order options or device settings