Endress+Hauser Proline Prosonic Flow P 500 - Page 35

Proline Prosonic Flow P 500
Endress+Hauser 35
Current output 0/4 to 20 mA
Standard installation cable is sufficient.
Pulse/frequency/switch output
Standard installation cable is sufficient.
Pulse output, phase-shifted
Standard installation cable is sufficient.
Relay output
Standard installation cable is sufficient.
Current input 0/4 to 20 mA
Standard installation cable is sufficient.
Status input
Standard installation cable is sufficient.
Connecting cable between the transmitter and sensor
4
3
1
2
A0041974
1 Non-hazardous area
2 Hazardous area: Zone 1; Class I, Division 1 or Zone 2; Class I, Division 2
3 Proline 500 transmitter
4 sensor set with sensor cable to transmitter 500 →  35
Transmitter and sensor installed in the hazardous area: Zone 1; Class I, Division 1 oder Zone 2;
Class I, Division 2
Sensor cable for sensor - Proline 500 transmitter
Standard cable • TPE: -40 to +80 °C (-40 to +176 °F)
• TPE armored: -40 to +80 °C (-40 to +176 °F)
• TPE halogen-free: -40 to +80 °C (-40 to +176 °F)
• PTFE: -50 to +170 °C (-58 to +338 °F)
• PTFE armored: -50 to +170 °C (-58 to +338 °F)
Cable length (max.) 30 m (100 ft)
Cable lengths (available for
order)
5 m (15 ft), 10 m (32 ft), 15 m (50 ft), 30 m (100 ft)
Operating temperature Depends on the device version and how the cable is installed:
Standard version:
• Cable - fixed installation
1)
: minimum –40 °C (–40 °F) or –50 °C (–58 °F)
• Cable - movable: minimum –25 °C (–13 °F)
1) Compare details under the "Standard cable" row