Endress+Hauser prosonic flow 92 - Page 92

11 Description of device functions Prosonic Flow 92
92 Endress+Hauser
System Simulation Current
Use this function to define a freely selectable value (e.g. xx % of full scale) to be output at the current out-
put. This value can be used to test downstream devices and the measuring device itself.
User input:
Floating-point number: –20.00...120.00 %
Factory setting:
0.00 %
Caution!
• The “SIMULATION CURRENT” function is enabled as soon as the group “SYSTEM” is selected.
• The setting is saved if the power is turned off and on.
Note!
To disable the “SIMULATION CURRENT” function, exit the group “SYSTEM”.
System SW-Rev. Amplifier
Use this function to display the product designation and the software revision number of the amplifier.
Example:
V 1.00.00 (original software)
Prosonic Flow 92