RIA45 Commissioning
Endress+Hauser 21
7 Commissioning
7.1 Post-installation check and switching on the device
Make sure that all post-connection checks have been carried out before you commission
your device:
• ‘Post-installation check’ checklist → 10
• ‘Post-connection check’ checklist → 13
Once the operating voltage is applied, the display lights up and the green LED indicates
that the device is operational.
When you commission the device for the first time, you program the setup in accordance
with the descriptions provided in these Operating Instructions in the following sections.
When commissioning a device already configured or preset, measuring is immediately
started as per the settings. The values of the channels currently activated appear on the
display. Changes to the display can be made in the Display menu item → 31.
Remove the protective foil from the display as this restricts display legibility
otherwise.
7.2 General information on the device configuration
You can commission/configure your device locally using the three integrated keys, or by
PC. You require the Commubox FXA291 to connect the device to a PC (see ‘Accessories’
section).
Advantages of configuring the device using FieldCare Device Setup:
• The device data are saved in the FieldCare Device Setup and can be called up at any time.
• Entries can be made more quickly using the keyboard.
7.3 Notes on setup access protection
Access to the setup is enabled when the device leaves the factory. Access can be locked via
the setup.
Proceed as follows to lock the device:
1. Press E to get to the configuration menu.
2. Press +, Setup is displayed.
3. Press E to open the Setup menu.
4. Press + again until System is displayed.
5. Press E to open the System menu.
6. Access code is displayed.
7. Press E to open the configuration of the access protection.
8. Set the code: the desired numerical value is configured by pressing the + and - keys.
The access code is a four-digit number. The corresponding position of the number is
displayed in plain text. To confirm the value entered and to go to the next position,
press E.
To Next Page
Loading...
