Endress+Hauser ria45 - System Configuration Settings; Diagnostics Menu Options

Appendix RIA45
66 Endress+Hauser
Description Time base for gradient calculation in seconds
User entry 0-60
Factory setting 0
Additional information Only visible if "Function" = "Gradient" was set
Hysteresis
Navigation

Setup → Relay 1/Relay 2 → Hysteresis
Description Hysteresis for switching threshold(s)
User entry Numerical value
1)
Factory setting 0
Submenu "System"
Navigation

Setup → System
Access code
Navigation

Setup → System → Access code
Description User code to protect the device configuration.
User entry 0000…9999
Factory setting 0000
Additional information 0000 = protection through user code disabled
Overfill protect
Navigation

Setup → System → Overfill protect
Description If the device is used for overfill protection →  31, "Yes" must be selected
for "Overfill protect".
Options no
yes
Factory setting no
Reset
Navigation

Setup → System → Reset
Description Resets the device to the order configuration.
Options no
yes
Factory setting no
1) Numerical values consist of 6 digits where the decimal point counts as a digit, e.g. +99.999
14.4 Diagnostics menu
Current diagn