Endress+Hauser RMS 621 - Page 48

6 Commissioning RMS 621
48 Endress+Hauser
Setup → Communication
As a standard an RS232 interface is fitted to the front of the unit and an RS485 interface is available
on terminals 101/102.
Sub menu Setup (all parameters) Æ Communication.
Simulation 0.0 Hz - 0.1 Hz - 1.0 Hz -
5.0 Hz - 10 Hz - 50 Hz -
100 Hz - 200 Hz - 500 Hz
- 1000 Hz - 2000 Hz
Off
In this addressthe pulse output function can be simulated.
Simulation is active if the setting is not "off". Simulation ends if
you leave this address.
Function (Menu
address)
Parameter set-up Description
Unit address 0 to 99
00
Unit address for communication using the serial interface.
RS232
Baudrate 9600
19200
38400
57600
Baudrate for the RS232 interface
RS485
Baudrate 9600
19200
38400
57600
Baudrate for the RS485 interface
Function (menu item) Parameter setting Description