Endress+Hauser Soliwave FDR56 - Page 24

Soliwave FQR56/FDR56
Electrical connection
24
Endress+Hauser
6�3�1 Connection of F16 (plastic) housing
1
2
3
4
5
1
2
3
4
5
12 DeviceconnectionF16housing
1 Connectionterminals
2 Potentialequalizationconnection
3 Cablegland
 (clampingareas5to10mmasperEN50262or7to10mmasperUL-514B)
4 Connectioncable
5 Matingconnector(optionalwithprefabricatedconnectioncable)
Procedure of connection with terminals and cable glands:
Screwthecapnuttightuntiltherubbersealistouchingthecableonallsides,tightencap
nut with by ½ turn.
Connect the power supply and signal output.
Connect the protective ground.
Procedure of connection with connectors:
Connect the protective ground.
Connecttheconnectorsandxthem.