Endress+Hauser Soliwave FDR56 - Resetting to Factory Defaults (Function F)

Soliwave FQR56/FDR56
Commissioning
42
Endress+Hauser
8�5 Resetting to factory defaults (function F)
You can reset the FDR56 to its factory defaults with this function as follows:
Move the encoding switch to position F
→Displayofthefunctionnumber
→AllLEDsgooutaer2seconds.
Press the and keys on the device to set it to the factory defaults
→AllLEDsilluminateasconrmation.
Move the encoding switch to the initial position 0
→Displayofthecurrentsignalstrength
Overview factory defaults:
Function Description Default value
5
Hysteresis
6 Limit signal function
7 Switch-on delay
8 Switch-odelay
A Damping
• All unlisted functions are automatic functions without factory default.
• Overview device functions
→54