2-Pack Analyzer System
1–2 4900002256 rev. B 4-13-21
within this manual and must be observed when operating and servicing the
analyzer. Some symbols are provided for instructional purposes only and are
not labeled on the system.
Safety warning label
The warning label shown below will be affixed to the front side of all analyzer
enclosures that contain sample gas.
Hazards may vary by stream composition. One or more of the following
conditions may apply.
Flammable. Gases used in the processing of this analyzer may
be extremely flammable. Any work in a hazardous area must be
carefully controlled to avoid creating any possible ignition sources
(e.g., heat, arcing, sparking, etc.).
Toxins. SpectraSensors analyzers measure a variety of gases,
including high-level H
2
S. Follow all safety protocols governing
toxic gases and potential leaks.
Inhalation. Inhaling toxic gases or fumes may cause physical
harm or death.
Technicians are expected to follow all safety protocols established
by the customer that are necessary for servicing or operating the
analyzer. This may include, but is not limited to, lockout/tag-out
procedures, toxic gas monitoring protocols, personal protective
equipment (PPE) requirements, hot work permits and other
precautions that address safety concerns related to performing
service or operation on process equipment located in hazardous
areas.
To Next Page
Loading...
Need help?
General
