SS2100i-1 and SS2100i-2 Analyzer
1–2 4900002288 rev. B 1-13-21
Conventions used in this manual
In addition to the symbols and instructional information, this manual is created
with “hot links” to enable the user to quickly navigate between different
sections within the manual. These links include table, figure and section
references and are identified by a pointing finger cursor when rolling over
the text. Simply click on the link to navigate to the associated reference.
Safety warning label
The warning label shown below will be affixed to the front side of all analyzer
enclosures that contain sample gas.
Hazards may vary by stream composition. One or more of the following
conditions may apply.
Flammable. Gases used in the processing of this analyzer may
be extremely flammable. Any work in a hazardous area must be
carefully controlled to avoid creating any possible ignition sources
(e.g., heat, arcing, sparking, etc.).
Toxins. SpectraSensors analyzers measure a variety of gases,
including high-level H
2
S. Follow all safety protocols governing
toxic gases and potential leaks.
Inhalation. Inhaling toxic gases or fumes may cause physical
damage or death.
Technicians are expected to follow all safety protocols established
by the customer that are necessary for servicing or operating the
analyzer. This may include, but is not limited to, lockout/tag-out
procedures, toxic gas monitoring protocols, personal protection
equipment (PPE) requirements, hot work permits and other
precautions that address safety concerns related to performing
service or operation on process equipment located in hazardous
areas.
To Next Page
Loading...
Need help?
General
