To Next PageTo Next PageWhat to do if I have leaks (gas) in my Endress+Hauser SpectraSensors SS2100i-1 Measuring Instruments?
If you detect gas leaks in your Endress+Hauser Measuring Instruments, use a liquid leak detector at all fittings to identify and resolve the source of the leak.
What to do if I have low pressure or flow in my Endress+Hauser SpectraSensors SS2100i-1 Measuring Instruments?
If you're experiencing low pressure or flow with your Endress+Hauser Measuring Instruments, consider the following steps: * Check, clean, or replace filters or membrane separators. * Check and adjust the sample probe regulator. * Inspect for any leaks. * Check the sample probe or the sample transport tubing and clean them, if needed. * Check the relief valve for proper setting.
What to do if there are liquids in the flow meter of my Endress+Hauser SpectraSensors SS2100i-1 Measuring Instruments?
If you find liquids in the flow meter of your Endress+Hauser Measuring Instruments, verify the temperature for the SCS. Also, check the pressure and correct as necessary. Finally, check the temperature on the sample tubing and correct it as needed.
What to do if electrical noise interferes with Endress+Hauser Measuring Instruments?
If you're experiencing issues with electrical noise affecting the stability of your Endress+Hauser Measuring Instruments laser operation, it may be due to high levels of electrical noise interfering with the laser. To address this, ensure that the analyzer is always connected to a properly grounded power source.
Why is the reading erratic on Endress+Hauser Measuring Instruments?
If the reading on your Endress+Hauser Measuring Instruments is erratic or seems incorrect, especially if the readings are much higher than expected, it may be due to contamination in the sample system. Check the sample system for any contamination.
What to do if Endress+Hauser Measuring Instruments is not getting enough flow?
If you're not getting enough flow to the sample cell in your Endress+Hauser Measuring Instruments, check both the micro filter and membrane separator for contamination. Also, check if the supply pressure is sufficient.
Why is the front panel display not lit on Endress+Hauser Measuring Instruments?
If the front panel display of your Endress+Hauser Measuring Instruments is not lit and no characters appear, check for correct voltage on the terminal block input. Also, check for correct voltage after the fuses. Then, check for 5 VDC on red wires, 12 VDC on yellow wires, and 24 VDC on orange wires from the power supply. Finally, check connections on the display communication and power cables.
How to prevent contamination in Endress+Hauser Measuring Instruments?
General| Device Type | Gas Analyzer |
|---|---|
| Measurement Principle | Tunable Diode Laser Absorption Spectroscopy (TDLAS) |
| Response Time | < 2 seconds |
| Power Supply | 24 VDC |
| Communication Protocol | Modbus RTU |
| Enclosure Rating | IP66 |
| Operating Temperature | -20°C to +50°C |
| Output | 4-20 mA |
| Dimensions | Depends on configuration |
| Approvals | ATEX, IECEx |
| Mounting | Wall or Pipe Mount |
