Maintenance & Troubleshooting
Hardware Installation and Maintenance Manual B
–29
initiated by pressing the # key followed by the 2 key to enter Mode
2 and then pressing the # key followed by the 1 key to return to
Mode 1.
6. Turn off the purge supply.
7. Allow all residual gas to dissipate from the lines.
8. Close any valves controlling the sample flow effluent to the low
pressure flare or atmospheric vent.
9. Disconnect power to the system.
10. Disconnect all tubing and signal connections.
11. Cap all inlets, outlets, vents or gland openings (to prevent foreign
material such as dust or water from entering the system) using the
original fittings supplied as part of the packaging from the factory.
12. Pack the equipment in the original packaging in which it was
shipped, if available. If the original packaging material is no longer
available, the equipment should be adequately secured (to prevent
excessive shock or vibration).
13. If returning the analyzer to the factory, contact Service for a
Decontamination Form. Refer to “Service Contact” on page B-27.
Attach the form to the outside of the shipping package as instructed
before shipping.
Storage
The packaged analyzer should be stored in a sheltered environment that is
temperature controlled between -20
C to 50 C (-4 F to 122 F), and should
not be exposed to rain, snow, caustic or corrosive environments.
Disclaimers
SpectraSensors accepts no responsibility for consequential damages arising
from the use of this equipment. Liability is limited to replacement and/or repair
of defective components.
This manual contains information protected by copyright. No part of this guide
may be photocopied or reproduced in any form without prior written consent
from SpectraSensors.
Warranty
For a period of 18 months from date of shipment or 12 months in operation,
whichever comes first, SpectraSensors warrants that all products sold by it
shall be free from defects in material and workmanship under normal use and
service when correctly installed and maintained. SpectraSensors’ sole liability
and Customer’s sole and exclusive remedy for a breach of warranty is limited
to SpectraSensors’ repair or replacement (at SpectraSensors’ sole option) of
To Next Page
Loading...
Need help?
General
