Hardware Installation and Maintenance Manual C–1
Appendix C: Analyzer Parts
This chapter provides lists and illustrations of all field replaceable parts used in
the SS2100i-1 analyzer. Due to a policy of continuous improvement, parts and
part numbers may change without notice.
Not all parts listed are included on every analyzer. When ordering, please
specify the system serial number (S/N) to ensure that the correct parts are
identified.
Table C–1 Replacement parts for electronics panel assembly
Figure
Number
Reference
Number
Part
Number
Description
C–3 1 2100002097 One Phase Filter Model FN2415
C–2 2 4500002002 Relay, with Socket, C1D2, 6 A,
DC12 V, SPDT
C–2 3 4500002014 Thermostat, Manual Reset, 2455RM
C–1 4 2900000460 PCB, Assembly, Hytek Controller,
28 Meter
C–1 5 2900000410 Assembly, PCB, Backplane, Relay/
No Relay Option
C–3 6 8000002013 Assembly, Power Supply, Traco
C–1 7 2900000380 Assembly, PCB, Daughter, H
2
S, ARM9
C–3 8 2900000450 Assembly, PCB, 4-20 mA, Dual Adjust,
Low Noise
C–1 9 2900000420 Assembly, PCB, EAE-TDL, No
Ethernet-Hybrid
C–3 10 EX4000000001 Power Supply, 100 to 240 VAC, 24
VDC / 1.3 A
C–1 11 8000002526 Assembly, Phycore-ARM9/LPC3180
and Carrier
C–3 12 2900000440 Assembly, Analog Input Board
C–3 13 3100002152 Signal Converter, RS-232 to RS-485,
-40 °C to +80 °C
To Next Page
Loading...
