S o n o m a U s e r M a n u a l
86
C H A P T E R N I N E
87
S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
Command: upgradekernel
Sonoma reply: Shows progress indicator.
upgraderootfs
This utility allows you to upgrade the Linux Root File System. It is run after the rootfs.gz le has
been copied to the /tmp directory on the system. It performs an erase of the upgrade root le system
partition and then writes the /tmp/rootfs.gz le to it. Refer to Appendix B - Upgrading the Firm-
ware, Performing the Linux Subsystem RFS Upgrade for detailed information..
Command: upgraderootfs
Sonoma reply: Shows progress indicator.
upgradercvr
This utility allows you to upgrade the CDMA Receiver rmware. (Prior to executing this command,
you must copy the binary rmware le to be uploaded to the CDMA Receiver to /tmp/rcvr.bin.)
It issues the commands over the serial port to the CDMA Receiver that are needed to start the X-
modem le transfer, and then displays progress to the console. See Performing the CDMA Receiver
Upgrade in Appendix B - Upgrading the Firmware for more information.
Command: upgradercvr
Sonoma reply: Upgrade progress is shown.
upgradesubsys
This utility allows you to upgrade the CDMA Subsystem rmware. (Prior to executing this com-
mand, you must copy the binary rmware le to be uploaded to the CDMA Subsystem to /tmp/
subsys.bin.)
It issues the commands over the serial port to the CDMA Subsystem that are needed to start the X-
modem le transfer, and then displays progress to the console. See Performing the CDMA Subsys-
tem Upgrade in Appendix B - Upgrading the Firmware for more information.
Command: upgradesubsys
Sonoma reply: Upgrade progress is shown.
wrt_sw_opt
See Chapter 10 - Options, Software Options for information on this command.
To Next Page
Loading...
