EndRun Sonoma D12 - Faults: Fault Mask

S o n o m a U s e r M a n u a l
62
C H A P T E R S E V E N
63
S o n o m a U s e r M a n u a l
H T T P S I N T E R F A C E
Faults: Fault Mask Page
Fault Masks
Signal Fault This eld shows the current mask setting for the Signal Fault, either Masked or
Enabled. When the signal fault is Masked it will prevent a Signal Loss Fault
from occurring. Some installations may need to mask this fault when operating
the Sonoma with no CDMA signal. (An example of this would be when
congured as a Stratum 2 NTP Server.) To change the Signal Fault Mask use
the setsigfltmask command, or the front-panel keypad/display.
Primary and These elds will display ONLY if your Sonoma has the Dual Power Supply
Secondary Power option installed. See Chapter 10 - Options, Masking Dual Power Supply
Fault Alarms Fault Alarms for more information.
Network: IPv4 Page
This page shows the IPv4 network conguration. Fields are:
IPv4 Network Status
DHCP By default, the Sonoma will congure itself using the Dynamic Host
Conguration Protocol (DHCP). If you need to set up static IP conguration,
you must use the netconfig command via the console port. Thie eld will
show whether DHCP is enabled or disabled.
Address, Gateway, These elds show the settings for the IP address, gateway and netmaks.
Netmask To change these esttings use the netconfig command via the console port.
Network: IPv6 Page
This page shows information related to the IPv6 network parameters. For more information on IPv6
see Chapter 8 - IPv6 Information.
Network: DNS Page
This page shows the IP addresses of the primary and secondary domain name servers.
Network: MAC Address Page
This page shows the media-access-control (MAC) address for both Ethernet ports (eth0 and eth1).
NTP Page
The NTP Status page shows all information related to NTP operation. Fields are:
NTP Status
Status The stratum eld has several possible values:
Stratum 1: The server is fully synchronized and accurate.
Stratum 2: The server is synchronized to a Stratum 1 server.
Stratum x: The server is synchronized to a Stratum x-1 server.
Stratum 16: The server is unsynchronized. NTP clients will not use a
Stratum 16 server.