EndRun Sonoma D12 - PTP: Status and Configuration Pages; Firmware: Firmware Status Page

S o n o m a U s e r M a n u a l
64
C H A P T E R S E V E N
65
S o n o m a U s e r M a n u a l
H T T P S I N T E R F A C E
Source This eld will show the source of time which is usually CDMA. If the Sonoma
is congured as a Stratum 2 server then it will show the IP address of the
upstream Stratum 1 server.
Offset This eld shows the offset in seconds between the NTP system clock and the
CDMA Subsystem clock. Positive implies that the NTP system clock is ahead
of the CDMA Subsystem clock.
Leap Indicator This eld shows whether a leap second is pending.
Leap seconds occur every 2-3 years. Possible indicator values are:
00: Normal, locked operation.
01: Leap second insertion event will occur at UTC midnight.
10: Leap second deletion event will occur at UTC midnight.
11: Fault. Unsynchronized state.
I/O Statistics
Time Since Reset, These elds show statistics accumulated since the last reboot of the system.
Packets Sent/Received,
Sent Rate,
Packets Dropped
PTP: Status and Configuration Pages
The elds on these pages show the status and the conguration for the optional PTP/IEEE-1588 pro-
tocol. If your Sonoma does not have PTP enabled then there will be no elds shown. For more infor-
mation on PTP and an explanation of the data elds on this page see Chapter 4 - PTP/IEEE-1588.
Firmware: Firmware Status Page
The rmware status page shows part numbers and revisions for Sonoma rmware.
Firmware Status
Linux RFS PN, These elds show the Linux Root File System part number, version & date.
Linux RFS Version
Linux Kernel PN, These elds show the Linux Kernel part number, version & date.
Linux Kernel Version
CDMA Subsystem This eld shows the CDMA Subsystem rmware version.
Firmware
CDMA Subsystem This eld shows the CDMA Subsystem Field Programmable Gate Array (FPGA)
FPGA version.
CDMA Receiver This eld shows the CDMA Receiver rmware version.
Firmware
CDMA Receiver This eld shows the CDMA Receiver FPGA version.
FPGA