EndRun Sonoma D12 - Chapter Seven - Hyper Text Transport Protocol Secure (HTTPS)

S o n o m a U s e r M a n u a l
38
C H A P T E R F O U R
39
S o n o m a U s e r M a n u a l
P T P / I E E E - 1 5 8 8
10ms Clock is synchronized or in holdover, PTP clock < 10 milliseconds
Unknown Clock is unsynchronized, TFOM = 9
The PTP Leap 59 second indicator is either TRUE or FALSE. The Leap 59 is TRUE if the PTP Tim-
escale is PTP and the last minute of the current UTC day contains 59 seconds, otherwise it is FALSE.
The PTP Leap 61 second indicator is either TRUE or FALSE. The Leap 61 is TRUE if the PTP Tim-
escale is PTP and the last minute of the current UTC day contains 61 seconds, otherwise it is FALSE.
The PTP Time Traceable indicator is either TRUE or FALSE. The Time Traceable is TRUE if the
Time Scale is PTP and the Clock Class is Synchronized or Holdover, otherwise it is FALSE.
The PTP Frequency Traceable indicator is either TRUE or FALSE. The Frequency Traceable is
TRUE if the Time Traceable is TRUE, otherwise it is FALSE.
About the PTP Second
and UTC Time
The PTP Time Mode selections are PTP and UTC. The IEEE-1588 standard denes the PTP epoch
beginning at 0 hours on 1 January 1970. The time measured since this epoch is designated in the
standard as PTP seconds. The PTP second is monotonic so does not include leap seconds.
Unlike PTP, the UTC second is not monotonic, that is, from time-to-time there will be leap second
insertions. The last second of a leap insertion day is 23:59:60 making the day one second longer than
a normal day ending at 23:59:59.
PTP Second
When the PTP Time Mode is set to PTP, the slave clocks must utilize the current leap second and leap
second pending ags (leap_59 or leap_61) to convert the PTP second to UTC.
UTC Time
When the PTP Time Mode is set to UTC, then there will be a one second jump in time when a leap
second insertion occurs. If the PTP slave does not account for this, it will also jump. Avoid this by
using PTP Time Mode.
Multiport PTP
When only one PTP option is enabled it will be congured for eth0 PTP Domain 0. If a second PTP
option is enabled then it will be congured for eth1 PTP Domain 1. This conguration will allow
PTP to run as master on both ports.
If the PTP Domain is congured as the same value for both ports (for example, PTP Domain 0 on
eth0 and PTP Domain 0 on eth1) then eth0 Port State will be master and eth1 Port State will be
listening.