EndRun Sonoma D12 - Problems with the CDMA Subsystem Upgrade

S o n o m a U s e r M a n u a l
120
A P P E N D I X B
121
S o n o m a U s e r M a n u a l
U P G R A D I N G T H E F I R M W A R E
Problems with the CDMA Subsystem Upgrade
Should you have difculties with the upgrade due to a corrupt le, power failure during upload, or
other accident, do not be alarmed. Even though you may have lost the existing application program,
the CDMA Subsystem bootloader program will remain intact. Correct any problem with the binary
le and retry the upload procedure. If you are still unable to successfully perform the CDMA Sub-
system upgrade, you should contact Customer Support at EndRun Technologies.
Performing the CDMA Receiver Upgrade
This section has instructions for upgrading the CDMA Receiver. If you want to upgrade the CDMA
Subsystem see the section above called Performing the CDMA Subsystem Upgrade.
First you need to download the CDMA Receiver rmware from the EndRun website to a place on
your network which is accessible to the Sonoma. The link to the Sonoma upgrade page is shown
above.
You may transfer the le to your Sonoma using either ftp or scp. If you are using ftp to perform
the upgrade, transfer the previously downloaded le using binary transfer mode from the remote host
to this specic le on your Sonoma: /tmp/rcvr.bin. The CDMA Receiver image will be named with
the software part number and version like: 6010-0063-000_1.04.bin. When following the instruc-
tions below, substitute the name of the actual CDMA Receiver image that you are installing for
6010-0063-000_1.04.bin. You will be transferring the le to a temporary le, /tmp/rcvr.bin on your
Sonoma.
ftp remote_host {perform ftp login on remote host}
bin {set transfer mode to binary}
get 6010-0063-000_1.04.bin /tmp/rcvr.bin {transfer the le}
quit {close the ftp session after the transfer }
If you are using SSH to perform the CDMA Receiver upgrade, you may open another command win-
dow on the remote computer and securely transfer the CDMA Receiver image to /tmp/rcvr.bin using
scp from the remote computer. A command like this could be used:
scp –p 6010-0063-000_1.04.bin root@host.your.domain:/tmp/rcvr.bin
Now issue the following command to the Sonoma console to initiate the upload:
upgradercvr
This command performs the le transfer to the CDMA Receiver. You will see a le transfer progress
message while it is performing the transfer. Next, issue the following command to the Sonoma con-
sole to reset the CDMA Subsystem (and Receiver):
subsysreset
After it completes, wait about 60 seconds and issue this command to check the CDMA Receiver ver-
sion:
rcvrversion