EndRun Sonoma D12 - PTP Status Using the Network or Serial Port

S o n o m a U s e r M a n u a l
20
C H A P T E R T H R E E
21
S o n o m a U s e r M a n u a l
N E T W O R K T I M E P R O T O C O L ( N T P )
*******************************************************************************
*******************************************************************************
* *
* The Sonoma_D12 CDMA Network Time Protocol configuration has been updated. *
* *
* Please re-boot now for the changes to take effect. *
* *
*******************************************************************************
*******************************************************************************
*******************************************************************************
Configuring the Sonoma as a Stratum 2 Server
Operating the Sonoma as a Stratum 1 Server is the recommended mode. However, there are times
when Stratum 2 operation is a good strategy:
1. When you want a backup source of time. In this case, Sonoma will operate as a Stratum 1
Server as long as it is locked to the CDMA signal. If it loses the signal, then Sonoma will start to
drift away from “perfect” time. Eventually, when it has drifted 10 milliseconds, it reach the unlocked
condition and stop serving time on your network. If you have Sonoma congured for Stratum 2
operation, then it will continue serving time, using another Time Server as its reference. If Sonoma is
later able to acquire lock on the CDMA signal again, it will switch back to Stratum 1 operation.
2. When you want your Sonoma to serve accurate time, but you don’t want to use the antenna (for
some reason). In this case, Sonoma can operate solely as a Stratum 2 server, with no antenna con-
nected.
Since there are innumerable ways to congure your network with Stratum 2 servers, specic insruc-
tions for how to do that are beyond the scope of this manual. General instructions on how to edit the
ntp.conf le are below.
Edit ntp.conf File
You must edit the ntp.conf le in order to point your Stratum 2 server at a Stratum 1 server. Edit /etc/
ntp.conf and add your server line(s). (See Appendix C - Helpful Linux Information for information
on a simple editor.) Here is an example:
server 192.168.1.1
Or, if you have set up a domain name server via netconfig, here is another example:
server your.timeserver.com
IMPORTANT
Now save the edited le and copy it to the non-volatile ash partition with this command:
cp -p /etc/ntp.conf /boot/etc
Do not remove the server lines for the refclock. Even if your Time Server is not connected to an antenna,
the refclock server lines must remain.