EnGenius EAP1250 - Page 51

51
Using WDS (Wireless Distribution System) will allow
a network administrator or installer to connect to
Access Points wirelessly. Doing so will extend the wired
infrastructure to locations where cabling is not possible or
inefcienttoimplement.
Note: Compatibility between different brands and
models of Access Points is not guaranteed. It is
recommended that the WDS network be created using
thesamemodelsformaximumcompatibility.
Also Note: All Access Points in the WDS network must
use the same Channel and Security settings.
TocreateaWDSnetwork,pleaseentertheMACaddresses
of the Access Points that you want included in the WDS
network.Therecanbeamaximumoffour(4)AccessPoints.
Note: Only applicable in WDS AP and WDS Bridge modes.
2.4 GHz/5 GHz WDS Link Settings
Security: Select None or AES from the drop-down list.
AES Passphrase: Enter the Key Values you wish to use.
Other Access Points must use the same Key to establish a
WDS link.
MAC Address: Enter the Access Point’s MAC address to
whichyouwanttoextendthewirelessarea.
Mode:SelectDisable or Enable from the drop-down list.
Save: Click Savetoconrmthechanges.
WDS Link Settings