11g Wireless Client Bridge/AP Version 1.36
42
You can arrange the different data rate in distance in Access Point mode. Please
refer below table.
6M-24M 36M 48M 54M
High
ˇ ˇ ˇ Great
Ultra High
ˇ ˇ Great N/A
Super
ˇ Great NA N/A
Extreme
Great N/A N/A N/A
Preamble Type: For best performance, all devices on the wireless network should
use the same preamble type. However, the wireless network will still function even
though the wrong preamble type is used.
Broadcast SSID: This is a security feature that is enabled by default. This allows
clients on the wireless network to run a site survey and detect this Access Point.
Select Disabled if you do not want this Access Point detected in a site survey.
IAPP: It is recommended to Enable the Inter-Access Point Protocol (IAPP) if you
would like the clients on the wireless network to seamlessly roam between Access
Points of the same SSID.
802.11g Protection: If your wireless network is using both 802.11b and 802.g
devices then it is recommended to enable this feature so that the 802.11b devices
will not degrade the performance of 802.11g devices.
User Isolation: Click “Enabled” to stop packet transmission between Wireless
Clients.
Turbo Mode: Select “Enable” to activate the Turbo mode for better performance.
The Default is disabled.
Click on the Apply Changes button to confirm the changes. This device will
automatically restart once these changes have been applied.
5.4.3 Security
Click on the Security link under the Wireless menu. On this page you can configure
the authentication and encryption settings such as WEP, WPA, and 802.1x.
To Next Page
Loading...
