EnGenius ENH700EXT - Wireless Network and Security Settings

28
Spanning Tree Status
Enable the use of Spanning Tree on the ENH700EXT.
Bridge Hello Time
The amount of time before the connections times out.
Bridge Max Age The maximum amount of time the connection between
nodes will last.
Bridge Forward Delay
The amount of time to elapse before data is forwarded.
Priority
The priority of the device in the spanning tree.
7 2.4GHz Wireless and 5GHz Wireless
In both the 2.4GHz Wireless and 5GHz Wireless sections, the user will be able to configure
operation mode settings the 2.4GHz or the 5GHz radio respectively. The settings that will be
available to change is dependent on the selections chosen in Operation Mode (Chapter 6.1 -
Page 13) option in the System section of the user interface menu. For more information about
the modes of operation, refer to Chapter 3 (Page 10).
ENH700EXT can only operate a Client Bridge (WDS or not) or WDS Station on a
single band. It cannot operate bridges or stations concurrently on both 2.4GHz
or 5GHz.
The changes made in the 2.4GHz Wireless or 5GHz Wireless sections of the
ENH700EXT won’t be in effect until Save & Apply is selected in the Save/Reload
option of the Status section. Selecting Accept or Save in the 2.4GHz Wireless or
5GHz Wireless sections will not reconfigure the device.