Engine LanDrive - Hardware Installation

To Next Page

To Previous Page

Hardware Installation

Step 1 – Remove the two screws on the back

of the enclosure.

Step 2 – Loosen the four screws on the

surface of the unit.

Step 3 – The plastic bracket should slide out

effortlessly. Ensure that your hard drive

jumper setting is configured to Master.

Insert your hard drive. Connect the SATA

and power cables.

Step 4 – Secure your hard drive to the

bracket with the four screws included in the

package.

Step 5 – Re-insert the bracket and secure all

the screws that were previously removed.