ENSONIQ SQ-80 - Page 117

SQ-80 — Musician's Manual
The volume of the
Click Track is fixed, and is not affected by the Volume Control of the SQ-
80. With the Click ON, first adjust your mixer or amplifier so that the Click plays at an
appropriate level. Then use the Volume Control to set the Synthesizer volume to the proper level
relative to the
Click.
8. COUNTOFF
The Countoff is a one-Bar count which precedes a Sequence or Song, when it is played from the
beginning. This count can be with or without a
Click track. The available options are:
NONE — The Sequence begins playing immediately after you press Play or Rec/Play.
> QUIET — There is one measure of silence before the Sequencer begins to Play or Record.
This
is good when using the
SQ-80 with a Drum Machine — you can use the Drums as a lead-in instead
of the
SQ-80's Click.
> CLICK — There is one measure of Click track before the Sequence begins to play. In many
normal sequence recording situations. this setting.
COUNTOFF= CLICK, is the most useful.
10. LOOP
Determines whether a Sequence or Song will repeat after playing through once.
When ON:
At the end of a Sequence, or Song, the Sequencer will return to the beginning and
play it over again. It will continue to repeat until
STOP is hit.
When OFF:
The Sequence or Song will play once through and stop.
The setting of the
LOOP Switch is saved independently for each Sequence and Song.
Section 4 — The Sequencer
105