SQ-80 — Musician's Manual
[LOCATE] SEQUENCE LOCATE PAGE
Provides information about location within a Sequence; Allows access to any Bar within a
Sequence; Adjusts Tempo; Shows Time Signature and Selected Track.
( Inactive Buttons appear in White)
The LOCATE Page appears whenever the Sequencer is put into the Play mode from a non-sequencer
Page, and when the
LOCATE Button on the front panel is pressed. This Page provides valuable
Sequencer information as well as control over
Tempo and Auto-Locate functions.
The
Status of the Sequencer (whether it is in Play, Stop. Record, etc.) is always shown in the lower left-
hand corner of the Display on this Page. The currently selected
Track is displayed on the top row. (You
can't select a different Track from here: this Readout is just there to help you keep things straight.) I
no Track is selected (Straight Synth operation), it will read
TRACK=NONE.
'The
TEMPO Control is always active. Unless you have pressed GOTO, the Data Entry Slider and the
Up and Down Arrow Buttons will affect only the Tempo while you are on the
LOCATE Page. TEMPO
does not have to be selected.
The last three buttons on the
LOCATE Page are the Auto-Locate Controls. They allow you to quickly
go to any Measure within a Sequence, to back up one measure at a time, or to reset to the beginning o
the Sequence.
This section describes the
LOCATE Page as it appears when a Sequence is selected. When a Song is
selected, the
LOCATE Page is a little different (see SONG LOCATE Pau, p. 139).
READOUTS AND ACTIVE CONTROLS:
2. TRACK=
Tells you which of the eight Tracks is selected. If no Track is selected, it will read
TRACK=NONE.
4. SEQ=
Tells you which Sequence is selected.
106 Section 4 — The Sequencer
To Next Page
Loading...
