SQ-80 — Musician's Manual
Step 6:
> Press NEXT. The Display reads: STEP=06, TR=+00, SEQ=XX, REP=XX.
− Move the Data Entry Slider or the Up and Down Arrow Buttons until
SEQ=10.
> Press REP. Adjust to REP=04.
4) Check your Song
− > Press PREV to back up. one Step at a time, until you reach Step 1, Now use the NEXT and
REV
Buttons to move around the various Steps and check to see that they are right. If one of the values
is wrong, or if you just decide you want something different, simply select it, and change it.
5) Press *EMT* to exit to the EDIT Page.
Note:
Remember that a Song is just a series of pointers telling. the SQ-80 which Sequences to play, and
in which order. A Song contains no Track Data. It doesn't have to be saved — it just stays like it is until
you change it, or Erase it. You can't do any harm to a Sequence or any of its Tracks by anything you do
in Song Edit Mode. When playing back a Song, any changes you make to a Sequence will only be saved
if you instruct the
SQ-80 to save them, as described earlier.
[LOCATE] SONG LOCATE PAGE
Provides information about location within a Song; Allows access to any Step within a Song; Shows
Tempo and Time Signature.
I nactive Buttons appear i n White)
When a
Song is selected, the LOCATE Page looks a little different than in Sequence Mode. In Song
Mode the Page is reconfigured to show you where you are within a Song. The
Auto-Locate Controls
now locate to Song Steps rather than Bars.
The
Status of the Sequencer, whether it is in Song Play (SNGP) or Song Stop (SNGS) is always shown
in the lower left-hand corner of the Display on this Page.
Section 4 — The Sequencer
139
To Next Page
Loading...
