ENSONIQ SQ-80 - Page 177

SQ-80 — Musician's Manual
Files which contain no data (and are thus available for saving data to) will show "EMPTY FILE"
as the File Name, and TYPE=XXX as the File type. You can't load an Empty File.
> Find the Sequencer File you want to load. Again, its File Type must be ALL. If there are no
files of this type on the disk, press
*NO* to exit to the Storage Page. Once the file you want is
showing on the Display...
> Press
*YES*. The Display reads "ACCESSING DISK DRIVE..." while the data is
being Loaded. When the Load procedure is done, you are put on a Sequence Select Page.
and the Sequencer data from the disk File has replaced the Sequences and Songs that were previously
in memory.
Or Press
*NO* to cancel the procedure for any reason. •
Load a Bank of 40 Programs from disk:
> Insert the disk containing the Program data into the Disk Drive.
> Press the
Storage button to go to the Storage Page.
> Press DISK. The Disk Storage menu appears.
> Press
LOAD. The disk drive light goes on briefly and the Display says "READING
DIRECTORY FROM DISK." Then the Disk Load Menu appears as shown earlier.
•> Press
BANK. The following Dis
p
la
y
appears:
> Use the Data Entry Slider and
the Up and Down Arrow but-
tons to scroll through the 40
Program Bank Files on the
disk. For each of these files
you see, along the bottom row
of the Display:
• FILE NUMBER (shown as
FILE=
—
), the number of the
file, 01 through 40,
•
FILE NAME, the ten-character name which was given to the file when it was saved, and
•
FILE TYPE, which for Program Bank Files is TYPE=BNK.
Files which contain no data will show -EMPTY FILE" as the File Name, and TYPE=XXX. You
can't load an Empty File.
> Find the Program Bank File you want to load.
•> Press *YES*. The Display reads "ACCESSING DISK DRIVE..." while the data is being
Loaded. When the Load procedure is done, you are put on a Program Select Page, and the 40
Internal Programs from the disk File have replaced the Programs that were previously in the
Internal Memory.
Or Press
*NO* to cancel the procedure for any reason.
Section 6 — Data Storage 165