ENSONIQ SQ-80 - Page 180

SQ-80 — Musician's Manual
-> Find the Sequence File you want to Delete. Again, its File Type must be ONE. If there are no
files of this type on the disk, press *NO* to exit to the Storage Page. Once the file you want is
showing on the Display...
-> Press *YES*. The Display briefly reads "ACCESSING DISK DRIVE..." and returns to the
Storage Page. The file is Deleted and the Sequencer/Sys-Ex Block it occupied on the disk is now
available.
Or Press *NO* to cancel the procedure for any reason.
To Delete an ALL SEQUENCE File from the disk:
-> Insert the disk containing the Sequence data into the Disk Drive.
-> Press the
Storage button to go to the Storage Page.
-> Press DISK. The Disk Storage menu appears.
-> Press DELETE. The disk drive light goes on briefly and the Display says "READING
DIRECTORY FROM DISK." Then the Disk Delete Menu appears as shown above. -> Press
ALL. The following Display appears:
-> Use the Data Entry Slider and
the Up and Down Arrow but-
tons to scroll through the ten
Sequencer/Sys-Ex Blocks on
the disk. For each of these files
is shown, along the bottom row
of the Display, the FILE
NUMBER (shown as
FILE=
—
), the FILE NAME
(underlined) and the FILE TYPE (ONE, ALL or SYS).
When you Delete a file, its File Type must match the type that you selected in the previous step
— in this case. the type must be ALL.
-> Find the Sequence File you want to Delete. Once the file you want is showing on the Display... -
> Press *YES*. The Display briefly reads "ACCESSING DISK DRIVE..." and then returns to the
Storage Page. The file is Deleted and the Sequencer/Sys-Ex Block it occupied on the disk is now
available.
Or Press *NO* to cancel the procedure for any reason.
To Delete a Program Bank File from the disk:
-> Insert the disk containing the Program data into the Disk Drive,
-> Press the
Storage button to go to the Storage Page.
-> Press DISK. The Disk Storage menu appears.
-> Press DELETE. The disk drive light goes on briefly and the Display says "READING
DIRECTORY FROM DISK." Then the Disk Load Menu appears as shown above. -> Press
BANK. The following Display appears:
-> Use the Data Entry Slider and
the Up and Down Arrow but-
tons to scroll through the 40
Program Bank Files on the
disk.
− > Find the Program Bank
File you want to Delete.
− > Press *YES*. The
Display briefly reads
"ACCESSING
168 Section 6 — Data Stora
g
e