SQ-80 — Musician's Manual
Of course, since two Modulators can be selected, you could apply both of these Modulators (or any other
combination) to the Filter Cutoff Frequency, and their effect would be added together. and then added
to the Manual Level.
As with Oscillator Volume, If the Manual
Level on the FILTER Page is set to FREQ. 00. the Filter
Cutoff Frequency will depend entirely on the depth and settings of any Modulators applied there.
Limits of Modulation
For all Modulation effects there is a maximum and a minimum range that cannot be exceeded. For
example, if the Filter Cutoff Frequency is manually set to its maximum value [127], you will not be
able to modulate the Frequency any higher, with an Envelope, LFO or other Modulator.
You cannot modulate an Oscillator's Output Level lower than Zero (silence). If a Modulator doesn't
seem to be having any effect, check that the other Modulators and manual settings are at appropriate
levels.
PROGRAMMING PAGES
The Page descriptions that follow encompass all the Program Parameters — those Parameters which
are saved with the individual Programs stored in the Memory of the SQ-80. To select any of these Pages,
press the corresponding button in the Voice Section of the Front Panel.
In case you wish to make a written record of the settings for a particular Program, you will find a blank
Program Parameter Sheet in the back of this Manual. Feel free to photocopy this sheet and use the
copies to record the Parameter settings.
Section 3 — Voice Programming 47
To Next Page
Loading...
