ENSONIQ SQ-80 - Page 60

SQ-80 — Musician's Manual
[OSC1] OSCILLATOR PITCH PAGE
[OSC2]
[OSC3]
Controls Oscillator pitch and selects the Wave to be played by each Oscillator.
(I Inactive Buttons appear
.
in White)
The format of the Oscillator Pitch Page is the same for [OSC 1], [OSC 2] and [OSC
3], although each
of these Pages is entirely independent.
Use these pages to:
1) Adjust the pitch of each Oscillator by octave, semitone, and fine increments;
2) Modulate the pitch of each Oscillator using any of the 15 available Modulation sources: and
3) Select the Waveform to be played by each Oscillator.
ACTIVE CONTROLS:
1. OCT
Adjusts the pitch of the Oscillator by octaves.
Range: -3 To +5.
2. SEMI
Adjusts the pitch of the Oscillator up by semitones (halfstep). Adjusting this control upwards
beyond 11 automatically increases the OCTAVE by one.
Range: 0 To 11.
3. FINE
Adjusts the pitch of the Oscillator up by fine steps (detunes). Each step here is about 3 Cents
(hundredths of a semitone).
Range: 0 To 31.
48 Section 3 — Voice Programming