SQ-80 — Musician's Manual
changes when switching between them. Also it is useful for balancing the relative levels of Split
and/or Layered Programs
(see SPLIT/LAYER Page, p.71).
Rance:
00 to 63.
Bear in mind that the overall Volume curve of the Program will depend on the setting of this
parameter and the settings on the
ENV 4 Page.
9. Select PAN Modulator
This control selects a Modulator for the PAN Setting. Modulators applied here will add to, or
subtract from, the Manual Level, just as they do elsewhere. Thus an
LFO used as a Modulator
here will make the Program Pan back and forth with Time. Applying
Velocity [VEL] here would
make a note's placement in the stereo mix depend on how hard you strike a key. And so on.
Or you can apply the Keyboard
(KYBD 2) as a Modulator to make the low keys play on the left
side, the middle keys in the middle, and the high keys on the right side of the stereo mix,
10. PAN Modulator Depth
Sets the amount by which the PAN Modulator will affect the Manual Pan Setting. Higher values
will cause more dramatic Pan Modulation. Negative Modulation Depths are particularly useful
here. Any Negative value here
(-32 for instance) will have exactly the opposite effect of the same.
Positive, value
(+32) in terms of how it affects the Pan of the Program (assuming a Manual Level
of
08).
Range:
-63 to +63.
Section 3 — Voice Programming
55
To Next Page
Loading...
Need help?
General
