Entrust nShield Connect - Page 38

Bond interface config
Update parameter
primary device: eth0
only valid for
active-backup mode
BACK NEXT
11.
Set the primary device field to the required option, either eth0 or eth1.
This parameter is only valid for active backup mode. This setting is ignored in other
modes.
12.
To accept, press the right-hand navigation button.
The following screen displays:
Bond interface config
Update parameter
resend igmp: 1
only valid for
active-backup mode
BACK NEXT
13.
Set the resend igmp field to the required value. Range: 0 - 255.
This parameter is only valid for active backup mode. This setting is ignored in other
modes.
14.
To accept, press the right-hand navigation button.
The following screen displays:
Bond interface config
Are you sure you wish
to change the config ?
CANCEL CONFIRM
15.
To accept and apply changes to the bond config, press the right-hand navigation
button.
The following confirmation screen displays:
Bond interface
config completed OK
CONFIRM
nShield® Connect Installation Guide 38 of 73