9.2.5. Default gateway
9.2.5.1. Set default gateway for IPv4
To set a default gateway for IPv4:
1.
From the front panel menu, select System > System configuration > Network config
> Set default gateway > IPv4 Gateway.
The following screen is displayed:
Gateway configuration
Enter IPv4 address of
the default gateway:
0. 0. 0. 0
CANCEL NEXT
2.
Enter the IPv4 address of the default gateway.
3.
Press the right-hand navigation button NEXT and then FINISH to accept.
9.2.5.2. Set default gateway for IPv6
To set a default gateway for IPv6:
1.
From the front panel menu, select System > System configuration > Network config
> Set default gateway > IPv6 gateway.
The following screen is displayed:
Gateway configuration
Enter IPv6 address of
the default gateway:
CANCEL NEXT
Enter the address for the gateway. Press the right-hand navigation button. The
following screen is displayed if the address entered was a link-local address:
Gateway configuration
Select an interface for link-local address:
::
CANCEL NEXT
nShield® Connect Installation Guide 39 of 73
To Next Page
Loading...
