EasyManuals Logo

Entrust nShield Connect Installation Guide

Entrust nShield Connect
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
Select the interface for the IPv6 gateway. Press the right-hand navigation button to
accept.
9.2.6. Set up Routing
9.2.6.1. Set up routing for IPv4
To set a new route entry for IPv4:
1.
From the front panel menu, select System > System configuration > Network config
> Set up routing > New IPv4 route entry.
The following screen is displayed:
Edit route entry
Enter IP range
and mask length:
0. 0. 0. 0/ 0
Enter the gateway:
0. 0. 0. 0
CANCEL FINISH
2.
Enter the IPv4 address range details for the route. Press the right-hand navigation
button to accept.
9.2.6.2. Set up routing for IPv6
To set a new route entry for IPv6:
1.
From the front panel menu, select System > System configuration > Network config
> Set up routing > New IPv6 route entry.
The following screen is displayed:
Edit route entry
Enter the IP range
and prefix length:
::/64
CANCEL NEXT
2.
Enter the IPv6 address range details for the route. Press the right-hand navigation
button to accept. The following screen is displayed:
nShield® Connect Installation Guide 40 of 73

Table of Contents

Other manuals for Entrust nShield Connect

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Entrust nShield Connect and is the answer not in the manual?

Entrust nShield Connect Specifications

General IconGeneral
BrandEntrust
ModelnShield Connect
CategoryControl Unit
LanguageEnglish