Information and general warnings
2 Information and general warnings
2.1.1 Introduction
The instruction manual supplied with the burner:
• is an integral and essential part of the product and
must not be separated from the burner. It must therefore
be kept carefully for any necessary consultation and must
accompany the burner even if it is transferred to another
owner or user, or to another system. If the manual is lost or
damaged, another copy can be requested from EOGB on
request.
• is designed for use by qualied personnel.
• oers important indications and instructions relat-
ing to the installation safety, start-up, use and maintenance
of the burner.
Symbols used in the manual
In some parts of the manual you will see triangular DANGER
signs. Pay great attention to these, as they indicate a situa-
tion of potential danger.
2.1.2 General dangers
The dangers can be of 3 levels, as indicated below.
Maximum danger level!
This symbol indicates operations which, if not
carried out correctly, cause serious injury, death or
long-term health risks.
This symbol indicates operations which, if not car-
ried out correctly, may cause serious injury, death
or long-term health risks.
This symbol indicates operations which, if not
carried out correctly, may cause damage to the
machine and/or injury to people.
DANGER
WARNING
CAUTION
2.1.3 Danger: live components
This symbol indicates operations which, if not
carried out correctly, lead to electric shocks
with lethal consequences.
Other symbols
ENVIRONMENTAL PROTECTION
This symbol gives indications for the use of the
machine with respect for the environment.
DANGER
Delivery of the system and the instruction manual
When the system is delivered, it is important that the instruc-
tion manual is delivered to the user by the system manu-
facturer, with the recommendation to keep it in the room
where the heat generator is to be installed.
• The system supplier must carefully inform the user
about the use of the system;
• Any further tests that may be required before
activating the system;
• Maintenance, and the need to have the system
checked at least once a year by a representative
of the manufacturer or suitably qualied
technician.
To ensure a periodic check, the manufacturer recom-
mends the drawing up of a Maintenance Contract.
2.1 Information about this instruction manual and general warnings
To Next Page
Loading...