To Next Page

To Previous Page

EOS Vision - Installation and Operating Instructions EN-27

Installation

4 Unscrew 2 screws on the lower housing approx. 1 mm and remove the

lower housing from the heater. Do not unscrew the screws completely.

 The lower housing must only be removed if the heater is placed close

to a wall. The heater base must be accessible.

5 Screw the screws into the holes in the heater base and tighten them with

a ring or socket spanner.

6 Put the lower housing and lower back panel in place.

Questions and Answers:

Need help?

Do you have a question about the EOS Vision and is the answer not in the manual?

EOS Vision Specifications

General