5
EN-36 Installation and Operating Instructions - EOS Vision
Commissioning
EN
Commissioning
Before the heater can be commissioned, it must be filled with the supplied
sauna stones.
Before switching it on, ensure that the air inlets are free of lint. Remove any
lint with a moist towel.
The heater is switched on via the control panel for the control unit. It is
operated via the control panel.
WARNING
Fire hazard from overheating
Objects placed on the heater could catch fire. Herbs or similar sub-
stances used for aroma infusion purposes, which are located near
the heater, could catch fire.
Inspect the cabin prior to each use.
Start the sauna only after all air inlets and outlets have been
opened.
5.1 Filling with stones
The heater is intended for use with natural sauna stones. Use only stones of
the prescribed caliber of approx. 50–100 mm.
WARNING
Fire hazard from overheating
Operating the heater without stones could cause fire or damage to
the heater. Stones that are too small or are positioned too close to-
gether in the heater prevent hot air from being exhausted. This
leads to overheating of the heater.
Start the heater only if it has been filled with stones.
Ensure stones with the correct caliber are used: 50–100 mm.
Place the stones loosely in the rock store.
To Next Page
Loading...
Need help?
General
