EN-20 Installation and Operating Instructions - EOS Vision
Installation
EN
3.2 Heater guard rail
CAUTION
Risk of burns if heater is touched.
The outer casing of the heater may become hot and, if touched,
could cause burns.
It is essential that a heater guard rail is installed so that the unit
is protected from being touched.
A heater guard rail must be mounted around the upper edge of the heater.
It prevents accidental contact with hot parts of the heater.
You can purchase a suitable heater guard rail from the sauna heater manu-
facturer. See 2.4 Accessories (optional), EN-11
3.3 Preparing for installation
The heater is supplied packaged on a pallet. The heater and the base plate
sit separately on the pallet. Once the cabin is prepared, the heater and the
base plate are placed in a pre-defined position. Two people should always
transport the heater and the base plate.
Unpacking the heater and base plate
1 Remove the heater and base plate packaging.
Leave the heater and base plate on the pallet.
2 Remove all transport locks and protective films in the heater.
To Next Page
Loading...
