EN-40 Installation and Operating Instructions - EOS Vision
Service and maintenance
EN
6.2 Sauna stones
Sauna stones are a product of nature. Stones must be reshuffled depend-
ing on the frequency of use.
The process of heating and cooling can make the stones brittle.
Particular damage to the stones can be caused by aggressive sauna
essences, causing them to disintegrate over time. Small particles can break
free from the stones making the gaps between the stones smaller. This
means that hot air can no longer rise between the stones.
Check the sauna stones regularly and reshuffle them. Replace damaged
stones.
Please observe the following frequencies of time.
Use only natural sauna stones when you replace the old stones with new
ones. Due to their roughness, they produce a better water splash effect
than ceramic sauna stones.
Reshuffling the sauna stones
1 Switch off the heater from the control unit.
2 CAUTION! Caution: stones may be hot. Allow the heater to cool suffi-
ciently before you start to replace the stones.
Remove each stone individually.
3 Check each stone for damage.
Sort out any stones with severe damage.
Replace stones that have been sorted out: new stone caliber 50–
100 mm
4 Rinse all stones with cold water.
5 Place the stones loosely so that there is enough space between them for
air to circulate sufficiently.
Filling the rock store, EN-37
Commercial use Private use
Every 2–3 months Once per year
To Next Page
Loading...
Need help?
General
