6
EOS Vision - Installation and Operating Instructions EN-39
Service and maintenance
Service and maintenance
This sauna heater is made of low-corrosion material. To ensure a long ser-
vice life, take care of and perform regular maintenance on your sauna
heater.
Ensure that openings in the intake area and heat reflectors are never
blocked. These can easily become blocked with lint and dust as fresh air is
drawn in. This limits the air convection ability of the sauna heater and
could lead to impermissible temperatures. Clean and/or descale the units
as needed.
If you do not use your sauna for a longer period of time, ensure that at the
time of recommissioning no towels, cleaners or other objects are lying on
the sauna heater. Contact your sauna retailer or the manufacturer directly if
you notice malfunctions or signs of wear and tear.
6.1 Cleaning
The heater must be cleaned regularly. The cleaning frequency depends on
how often it is used.
CAUTION
Risk of injury from sharp edges
Use suitable personal protective equipment, e.g. gloves, when
cleaning parts with sharp edges.
Cleaning the heater
1 Switch off the heater from the control unit.
Wait until the heater is completely cool.
2 Clean the outside of the heater.
Use only household cleaning agents.
3 Remove lint and dust from openings and heat reflectors.
Openings can easily become blocked with lint and dust as fresh air is
drawn in. This limits the air convection ability of the heater and could
lead to impermissible temperatures.
To Next Page
Loading...
Need help?
General
