Epec 5050 - Software Channels for Pulse Inputs

Technical Manual 5050 / MAN000539 Page 32/92
Epec Oy reserves all rights for improvements without prior notice
Epec Oy Postiosoite/Postal address Puhelin/Phone Fax Internet
Tiedekatu 6 PL/P.O.Box 194 +358-(0)20-7608 111 +358-(0)20-7608 110 www.epec.fi
FIN-60320 Seinäjoki FIN-60101 Seinäjoki, Finland
4.4.4 Software Channels for Pulse Inputs
Possible software channels for pulse inputs are listed in the following table according to how
many channels are needed and if a possibility for a reset is required.
If there is no need for the reset functionality, reserve the pins from the bottom end.
This way the pins with the reset possibility remain free for possible future use.
Pin
Possible SW
Channels when
1 channel is
needed with no
reset
Possible SW
Channel pairs
when 2 channels
is needed with no
reset
Possible SW Channels
when 1 channel is
needed with a reset
Possible SW Channels
when 2-channel pulse
input is needed with a
reset
X2.06
1
pair 1
channel A channel A
X2.07
2
reset pin for the channel
above
channel B
X2.08
3
pair 2
channel A
reset pin for the channel
pair above
X2.09
4
reset pin for the channel
above
channel A
X2.15
5
pair 3
channel A channel B
X2.18
6
reset pin for the channel
above
reset pin for the channel
pair above
X3.07
7
pair 4
channel A channel A
X3.10
8
res
et pin for the channel
above
channel B
X2.16
9
pair 5
channel A
reset pin for the channel
pair above
X2.17
10
reset pin for the channel
above
channel A
X2.19
11
pair 6
channel A channel B
X2.20
12
reset pin for the channel
above
reset pin for the channel
pair above
X3.08
13
pair 7
not supported not supported
X3.09
14 not supported not supported
X3.11
15
pair 8
not supported not supported
X3.12
16 not supported not supported
X3.05
17
pair 9
not supported not supported
X3.06
18 not supported not supported
X3.21
19
pair 10
not supported not supported
X3.22
20 not supported not supported
X3.23
21
pair 11
not supported not supported
X1.11
22 not supported not supported