epic power CAN - RJ-45 Cable; CAN Bus Line Terminator

16
CAN - CANopen Interface
Installation guide
RJ-45 cable (Optional)
Cable used to connect diverse EPC interfaces together in a daisy-chain mode.
CAN Bus line terminator (Optional)
The CAN Bus requires to be terminated by a 120 Ohm resistor; this can be achieved in
a confident way by using our terminator (see Fig. 8) in the last CAN - CANopen interface.
Fig. 8 RJ-45 CAN Bus terminator (SKU: M.1001.0122)