Epiroc SmartROC T35 Maintenance

SmartROC T35/T40 9 Feed Unit
44 No: 7026962571.1.7027002891 en-US
9.9 Lubricate Rod Handling
n
Pump grease into the 14 grease nipples (A).
If Central Lubrication System (CLS) is installed, the functions and connections of CLS must
be checked.
9.10 Mounting Rock Drill on Cradle
1.
Clean the feeder using rust inhibitor
2.
Remove burrs, paint or other coatings from the cradle and the contact surfaces on the
rock drill.
3.
Remove the mounting bolts from the cradle.
4.
Position the rock drill with shims on the cradle.
5.
Check the rock drill fits firmly in place.
6.
Refit the bolts to the cradle.
7.
Check that the rock drill is properly positioned.
8.
Tighten the bolts alternately until the correct torque is achieved.
9.
Connect and fit the hoses to the rock drill.
Rock Drill Bolts Tightening
Torque
Metric Data Imperial Data
SmartROC T35 and T40 200 Nm 147.5 lb-ft

Epiroc SmartROC T35 Specifications

General

Brand	Epiroc
Model	SmartROC T35
Category	Industrial Equipment
Language	English