-40
R4C4600
html.bk Rev.C
PAPER.FM A5 size
7/24/01
L
Proof Sign-off:
ABE Y. Azuma, Nagasawa
Takahashi
ABE S.Halvorson
3. Load paper. Press the Load/Eject button to advance
continuous paper to the current top-of-form position. If
necessary, lift up the printer cover so you can see the paper
position.
4. Hold down the Pause button for about three seconds. The
Pause light starts flashing and the printer enters the Micro
Adjust mode.
5. Press the LF/FF D button to move the top-of-form position
down on the page, or press the Load/Eject U button to move
the top-of-form position up on the page.
Note:
❏ The printer has a minimum and a maximum top-of-form
position. If you try to adjust it beyond these limits, the printer
beeps and stops moving the paper.
❏ When the paper reaches the default top-of-form position, the
printer also beeps and stops moving the paper briefly. You can
use the default setting as a reference point when adjusting the
top-of-form position.
6. After you set the top-of-form position, press the Pause button
to exit the Micro Adjust mode.
To Next Page
Loading...
