Epson DLQ-3500 - Adjusting the Top-Of-Form Position

-39
R4C4600
html.bk Rev.C
PAPER.FM A5 size
7/24/01
R
Proof Sign-off:
ABE Y. Azuma, Nagasawa
Takahashi
ABE S.Halvorson
Note:
The printer has a minimum and a maximum tear-off position. If you
try to adjust the tear-off position beyond these limits, the printer
beeps and stops moving the paper.
5. Tear off the printed pages.
6. Press the Pause button to exit the Micro Adjust mode.
When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and begins printing.
Adjusting the top-of-form position
The top-of-form position is the position on the page where the
printer starts printing. If your printing appears too high or low
on the page, you can use the Micro Adjust function to adjust the
top-of-form position.
Follow these steps to adjust the top-of-form position:
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Note:
❏ Your top-of-form position setting remains in effect until you change
it, even if you turn off the printer.
❏ The top margin setting made in some application software overrides
the top-of-form position setting you make with the Micro Adjust
function. If necessary, adjust the top-of-form position in your
software.
1. Make sure the printer is turned on.
2. Press the Pause button to stop printing. The Pause light comes
on.