-13
R4C4600
html.bk Rev.C
CONTR.FM A5 size
7/24/01
R
Proof Sign-off:
ABE Y. Azuma, Nagasawa
Takahashi
ABE S.Halvorson
Note:
❏ To print the language selection and default-setting mode
instructions, you need three sheets of A4 or letter size single-sheet
paper or three pages of continuous paper that is at least 279 mm (11
inches) long and 210 mm (8.3 inches) wide. See “Loading
Continuous Paper” and “Loading Single Sheets” for instructions
on loading continuous paper and single sheets.
❏ If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet from the paper guide.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. Turn on the printer while holding down the Font button.
The printer enters the default-setting mode and prints the
language selection instructions (one page).
3. Press the Font button until the Font and Pitch lights indicate
the language you want, as described in the language selection
instructions.
4. Press the Tear Off/Special Paper button to print the
default-setting mode instructions (two pages) in the language
you selected.
The printed instructions list the settings you can change,
describe how to change them, and show you how the control
panel lights help you make settings. Use these instructions to
change the printer’s default settings from the control panel.
Note:
The arrows in the instructions indicate the printer’s current
settings.
To Next Page
Loading...
