Epson DLQ-3500 - Page 84

-8
R4C4600
html.bk Rev.C
TROUB.FM A5 size
7/24/01
L
Proof Sign-off:
ABE Y. Azuma, Nagasawa
Takahashi
ABE S.Halvorson
The paper supply is not
aligned with the printer.
Make sure you align your paper
supply with the paper loaded in the
tractor so the paper feeds smoothly
into the printer. See “Positioning the
continuous paper supply”.
The paper supply is too far
away from the printer.
Make sure that your paper supply is
within 1 meter (3 feet) of the printer.
The holes on the sides of the
paper are misaligned.
Check that the holes on the sides of the
paper are aligned with each other.
Also make sure the sprocket units are
locked and their covers are closed.
The paper-thickness lever is
set incorrectly.
Set the paper-thickness lever to match
the thickness of your paper. See
“Adjusting the Paper-Thickness
Lever”.
Your paper may be the
wrong size or thickness for
the printer.
Make sure that the paper size and
thickness are within the specified
ranges. See “Paper” for information
on the continuous paper
specifications.
The sprocket units are
positioned incorrectly for the
width of paper you are
using.
Adjust the position of the sprockets to
remove any slack along the width of
the paper.
Note:
If paper is jammed in the paper path,
see “Clearing a Paper Jam” for
instructions.
The printer does not eject your continuous paper properly.
Cause What to do