Specications for Plastic Cards for Scanning from the
Card Slot
ese are the specications for plastic cards that you can load into the scanner from the card slot.
Note:
❏ You can scan plastic cards from the card slot at the front. You cannot scan from the ADF.
❏ Although you cannot scan card from ADF, you can leave the ADF as the Document Source setting in Epson Scan 2.
Size Card Type Thickness Loading Capacity Loading Direction
ISO781A ID-1 Type
54.0×85.6 mm
(2.1×3.3 in.)
Without embossing 1.0 mm (0.04 in.) or
less
1 card Vertical (Portrait)
Types of Cards that Require Attention
e following types of cards may not be successfully scanned.
❏ ISO781A ID-1 Type plastic cards with emboss (the thickness should be 1.24 mm (0.05 in.) or less)
❏ ISO781A ID-1 size laminated cards (the thickness should be 0.6 mm (0.02 in.) or less)
Related Information
& “Placing Plastic Cards in the Card Slot” on page 48
Placing Standard Size Originals in the ADF
Specications of Standard Size Originals
ese are the specications for standard size originals that you can load into the ADF.
User's Guide
Specications of Originals and Placing Originals
28
To Next Page
Loading...
Need help?
General
