1.
Press the
button for more than 3 seconds to disable a Wi-Fi and AP mode connection.
e
light and light turn
o
when these are disabled.
Note:
Press the
button to re-connect Wi-Fi and AP mode.
Restoring the Network Settings from the Control
Panel
You can restore all network settings to their defaults.
1.
Turn the scanner o.
2.
While holding down the
button, press the button until light and light turn on simultaneously.
e
light and light ash alternately and then turn o when restoration is complete.
Adding or Replacing the Computer or Devices
>
Restoring the Network Settings from the Control Pa
…
185
To Next Page
Loading...
