Epson DS-570WII

1.
Access Web
Cong
, and then select the Device Management tab > Export and Import Setting Value >
Export.
2.
Select the settings that you want to export.
Select the settings you want to export. If you select the parent category, subcategories are also selected.
However, subcategories that cause errors by duplicating within the same network (such as IP addresses and so
on) cannot be selected.
3.
Enter a password to encrypt the exported le.
You need the password to import the
le.
Leave this blank if you do not want to encrypt the
le.
4.
Click Export.
c
Important:
If you want to export the scanner’s network settings such as the device name and IPv6 address, select Enable to
select the individual settings of device and select more items. Only use the selected values for the replacement
scanner.
Related Information
& “Running Web Cong on a Web Browser” on page 26
Import the settings
Import the exported Web Cong le to the scanner.
c
Important:
When importing values that include individual information such as a scanner name or IP address, make sure the
same IP address does not exist on the same network.
1.
Access Web Cong, and then select the Device Management tab > Export and Import Setting Value >
Import.
2.
Select the exported le, and then enter the encrypted password.
3.
Click Next.
4.
Select the settings that you want to import, and then click Next.
5.
Click OK.
e settings are applied to the scanner.
Related Information
& “Running Web
Cong
on a Web Browser” on page 26
Administrator Information > Backing Up the Settings > Import the settings
195